ARRMA Outcast 4S Body Skid/Reinforcement

No more holes through the hood of that beautiful Outcast body! The hood and roof skids are printed in nylon for high strength and impact resistance. The body reinforcement/bumper is printed using TPU, utilizing one 3D printing's biggest advantages: infill. By tuning the infill of the TPU, the bumper is designed to balance stiffness and energy absorption, helping to prevent body damage during impacts. 

All hardware needed is included!

Installation: 

Tools required: needle nose pliers, 2.5mm hex driver, and a 1/8" drill bit

• Start by aligning the hood skid to the contours of the hood, as shown in the picture (very important!)
• Drill the holes
• You have two lengths of bolts. The longest bolts go through the frontmost holes you created and will also be used to secure the TPU reinforcement. 
• Drop the small washers into the "eye" of the TPU reinforcement and secure with a nyloc nut. The needle nose pliers are to hold the nut within the "eye" (do not over tighten, you only need to make sure it is snug and that the bolt is past the nylon insert of the nut). 
• That is the hardest part done!
• Tighten down the other bolts for the hood (don't forget the washers)
• Throw on the roof skids and you're good to go! (pictures have been attached to help with alignment or just find a spot you like)